This is a kit to include all the parts I supply for an Exocutioner chassis with Dlux OD3 transmission, fusion motor DluxFab Shocks and using MEUS ISO Capra Axles
#NOTE: THIS IS NOT A COMPLETE TRUCK, ONLY PARTS I SUPPLY YOU WILL NEED TO GET THE PARTS LINKED BELOW TO COMPLETE YOUR EXOCUTIONER
This kit comes with
Rails (Black)
Fusion 650mah 3s Receiver/ Battery mount
OD3/Reefs OG Skid
Front Link Set
Rear Short linkset (APPROX 12.8" WB)
3 Printed chassis braces
TPU Body mounts for JConcepts Stagekillah Body https://alnk.to/gzXAFBA
You can also look at the other parts, if there is no difference in cost I can swap them out for you. Leave that info in the notes when you place your order
I will attempt to include all hardware needed, you will be responsible for some bolts based on your own build and setup. I will also make a bolt location sheet so you know what goes where.
Direct links to parts needed for THIS BUILD
MEUS ISO Capra Axle Set https://bit.ly/43qqGRv
JConcepts Stage Killah Body
Dlux OD3 GENUINE https://dluxfab.com/products/OD-3-Overdrive-Transmission-for-Straight-Axles-p522981000 get the right side motor option
Dlux OD3 Knockoff https://amzn.to/43stPAn
DLUX Fab Shocks https://dluxfab.com/products/Shocks-Suspension-c6232188 get the 92mm and one set of offset caps, the larger version for the front shocks
Cut to length Driveshafts I use these, cut the rear one first, if you cut it too short its now a front shaft https://amzn.to/43KGAFk
Carbon Fiber HIGH OFFSET wheels https://amzn.to/4mFIf7T
Rear wheel hexes https://amzn.to/451tANP
Front Wheel hexes use the 12mm version for easier fitment in front for knuckle clearance https://amzn.to/3T7lVWU
Spacers for shock clearance at chassis get the ones that are 5mm long https://amzn.to/4jBqW59
